Machine reference value
The recommended speed is 20,000 rpm Z-direction feed speed 100-300 When cutting, the cutting is layered, and the cutting depth is 0.5-5MM at a time. The processing speed is between 1000 and 3000. Coolant or water cooling must be turned on to prevent burning. The above numerical control machine parameters are for reference only, please adjust according to the actual situation. E.g: 1. If you want to increase the speed rate, the granite can be cut at a depth of 5mm, but the damage to the knife is relatively large. 2. But if you are engraving soft stone such as marble, bluestone, sandstone, and the height of the knife allows, you can directly cut to the end (provided that the cutting speed is appropriate and sufficient cooling water to ensure that the knife is not burned) do not stratify. That is, if the knife height is 10MM, the depth of 10MM can be cut directly. 3. Proper cutting speed must be set. Obviously, the cutting speed of 1cm deep under one cut cannot be the same as that of 1mm deep under one cut. Otherwise, moving the knife too fast under 10mm depth will cause excessive pressure and break the handle. 4. The coolant or water cooling must be turned on when using.
Widely applicable
Examples of stone carving
Scenario shows
